# EPOXY GLASS FLAKE ABRASION RESISTANT COATING RAINBOW PAINTS ## Product Code No.1074 (EP-150) ## Type Two-component high-performance anti-corrosion intermediate coating formulated with epoxy resin, special hardener and glass flake pigment. ## Application Anti-rust intermediate primer for steel structures such as water tanks, bridges, pipelines and factory equipment. ## Properties 1. Tough, rigid coating film with strong adhesion 2. Excellent fresh water and seawater resistance 3. Superior oil resistance 4. Powerful anti-rust performance 5. Outstanding abrasion resistance 6. Good UV penetration resistance ## Specification Data - Gloss: Gloss - Color: Silver Red - Hiding Power: ≥10 m²/L (mixed paint) - Specific Gravity: ≥1.35 kg/L (mixed paint) - Viscosity: 80~95 KU (25°C) - Drying Time - Surface dry: Within 3 hours (25°C) - Hard dry: Within 24 hours (25°C) - Full cure: 7 days (25°C) - Film Thickness: Wet film 415 μm, Dry film 250 μm - Theoretical Coverage: 1.9 m²/L, 10.0 m²/kg (@20μm dry film) - Recoating Interval: Min. 24 hours, Max. 3 days (25°C) - Volume Solids: 56% (mixed paint) - Pot Life: 4 hours at 25°C - Thinner: No.1005 Rainbow Thinner - Thinner Dosage: 5~10% (excluding tool cleaning) - Compatible Primers: Full series of Rainbow primers, No.1011 Inorganic Zinc Primer - Compatible Topcoats: Rainbow standard topcoat, ULI topcoat, chlorinated rubber topcoat - Storage Stability: Minimum 3 years under normal storage ## Application Methods Brush Coating, Airless Spray, Roller Coating ## Construction Precautions ⚠️ 1. Mix base and hardener evenly per specified ratio, stand 10~20 minutes for reaction before use. 2. Fully remove moisture, grease, sludge, dust, rust and corrosive salts from substrate surfaces to guarantee protective performance. 3. Avoid construction when surface dew exists, raining or relative humidity exceeds 85%RH; fully dry damp surfaces before coating. 4. Clean all tools thoroughly after use. 5. Ensure adequate ventilation during confined tank interior construction. 6. Roughen the coating surface if recoating interval exceeds the limit to improve interlayer adhesion. ## Note All datasheet data are internal laboratory test results for construction reference only. Actual performance varies subject to different construction environments. This document does not constitute any legally binding warranty or statement from the manufacturer. Contact our technical department for clarification of any uncertainties.